R&S
®
CMW 500 GPRF Applications
GPRF Command Reference
Operating Manual 1202.3986.32 – 03 182
SOURce:GPRF:GEN<i>:LIST:DGAin <Index>, <Gain>
SOURce:GPRF:GEN<i>:LIST:DGAin? <Index>
Defines or queries the digital gain of the frequency/level step numbered <Index>.
<Index>, Number of frequency/level step in the table (setting and query).
Range: 0 to 1999
Def
.
value: n/a
<Gain> Digital gain at the step (setting only)
Range: –30.00 dB to 0.00 dB (increment 0.01 dB),
Def. value: 0.0 dB,
Def. unit: dB
Example See Using the Generator List Mode
Characteristics Firmware version V1.00
7.4.3 Power Measurement Commands
The commands valid for the "Power" measurement are divided into the groups listed
below. For an overview of the commands refer to Command Groups.
Measurement Control and States
Measurement Parameters
Statistical Settings
Filter Settings
Trigger Settings
List Configuration
Measurement Results
The following general measurement settings also affect the "Power" measurement:
Signal Routing
Analyzer Settings
Issues of special interest for all commands:
MEAS<i> Abbreviation of "MEASurement<instance>". For better readability only
the abbreviated form (which is also accepted by the instrument) is given
in the command reference.
It is possible to use up to four instances of the same firmware
application in parallel.
For further information refer to Firmware Applications.
Issues of special interest in the context of result retrieval:
FETCh and
READ
commands
Both commands can be used to retrieve measurement results:
FETCh... returns the results of the current measurement cycle
(single shot measurement) after they are valid. FETCh... must be
To Next Page
Loading...
