Rohde & Schwarz CMW 500 - Abort:gprf:meas<I>:Epsensor; Fetch:gprf:meas<I>:Epsensor:state; Initiate:gprf:meas<I>:Epsensor; Measurement Control and States

R&S
®
CMW 500 GPRF Applications
GPRF Command Reference
Operating Manual 1202.3986.32 – 03 195
CONFigure:GPRF:MEAS<i>:EPSensor:ATTenuation:STATe...................................................................198
CONFigure:GPRF:MEAS<i>:EPSensor:ATTenuation...............................................................................199
Measurement Results Page
FETCh:GPRF:MEAS<i>:EPSensor? ........................................................................................................199
READ:GPRF:MEAS<i>:EPSensor? .........................................................................................................199
7.4.4.2 Measurement Control and States
The following commands control the measurement and return the current
measurement state.
INITiate:GPRF:MEAS<i>:EPSensor
ABORt:GPRF:MEAS<i>:EPSensor
STOP:GPRF:MEAS<i>:EPSensor
Starts, stops, or aborts the measurement; see Measurement Control:
INITiate... starts or restarts the measurement; the R&S CMW 500 enters the
"RUN" state.
ABORt... causes a running measurement to stop immediately; the R&S CMW
500 enters the "OFF" state.
STOP... causes a running measurement to stop after the current evaluation
period is terminated and valid results are available; the R&S CMW 500 enters the
"RDY" state.
Use FETCh...STATe? to query the current measurement state.
Example See Performing a Single Shot Measurement
Characteristics Firmware version V1.00
SCPI: No query
FETCh:GPRF:MEAS<i>:EPSensor:STATe?
Queries the main measurement state; see Measurement Control. Use
FETCh:...:MEAS<i>:...:STATe:ALL? to query the measurement state including
the substates. Use INITiate..., STOP..., ABORt... to change the
measurement state.
Returned values:
深圳德标仪器 135-1095-0799