Rohde & Schwarz CMW 500 - Measurement Control; Signal Routing and Analyzer Settings

R&S
®
CMW 500 WiMAX Applications
WiMAX GUI Reference
Operating Manual 1202.3986.32 – 03 377
10.2.1.1 Measurement Control
The measurement is turned on or off using the "Multi Evaluation" measurement control
softkey and the ON | OFF or RESTART | STOP front panel keys.
Multi Evaluation (Softkey)
Turns the measurement on or off; see Measurement Control. The measurement state
is shown in the softkey. Additional measurement substates may be retrieved via
remote control.
GPIB command:
INITiate:WIMax:MEASurement<i>:MEValuation etc.
FETCh:WIMax:MEASurement<i>:MEValuation:STATe?
FETCh:WIMax:MEASurement<i>:MEValuation:STATe:ALL?
10.2.1.2 Signal Routing and Analyzer Settings
The measurement is configured using the parameters in the "Multi Evaluation
Configuration" dialog. The following parameters configure the RF input path.
Multi evaluation configuration: Signal routing and analyzer settings
RF Routing
Selects the input connector for the measured RF signal; see connector selection.
GPIB command:
ROUTe:WIMax:MEASurement<i>:RFSettings:CONNector
External Attenuation (Input)
Defines the value of an external attenuation (or gain, if the value is negative) in the
input path.
The external attenuation also enters into the internal calculation of the maximum input
power that the R&S CMW 500 can measure (see "Expected Nominal Power" below).
GPIB command:
CONFigure:WIMax:MEASurement<i>:RFSettings:EATTenuation
深圳德标仪器 135-1095-0799