R&S
®
CMW 500 Preparing for Use
Connecting External Accessories
Operating Manual 1202.3986.32 – 03 18
Printer configuration
Use the "Start – Control Panel – Printers and Faxes" menu of Windows XP to
configure the printer properties.
1.5.4 Connecting a Monitor
A standard monitor can be connected to the DVI-D connector on the rear panel of the
R&S CMW 500 (option R&S CMW-B620A).
ATTENTION
Monitor connection
The monitor must be connected while the
instrument is switched off (in standby mode).
Otherwise correct operation can not be guaranteed.
The monitor displays the magnified R&S CMW 500 screen with all dialogs,
measurement results and control elements. No extra configuration is required.
Instrument control from the monitor
With an additional mouse or keyboard connected to the tester, you can control the
measurement from the external monitor.
You may also connect a VGA monitor using an appropriate adapter.
1.5.5 Connecting a LAN Cable
A LAN cable can be connected to one of the LAN connector
s on the front or rear panel
of the R&S CMW 500. To establish a LAN connection proceed as follows:
1. Refer to section Assigning an IP Address and learn how to avoid connection
errors.
2. Connect an appropriate LAN cable to one of the LAN ports. Use a commercial RJ-
45 cable to establish a non-dedicated network connection, or a cross-over RJ-45
cable to establish a dedicated connection between the tester and a single PC.
Dedicated vs. non-dedicated network connections
There are two methods to establish a LAN connection of the R&S CMW 500:
To Next Page
Loading...
