R&S
®
CMW 500 GPRF Applications
GPRF Measurements and Generators
Operating Manual 1202.3986.32 – 03 138
Retrigger All
Like "Retrigger Sweep", however, the trigger is re-armed after each power/frequency
step.
This mode is recommended if for steps with unknown or irregular distances.
7.1.2.4 Measurement Settings
The parameters for the "Power" measurement are accessible from the "Power
Configuration" dialog; see Power Parameters. In the measurement menu, various
softkey with associated hotkeys provide fast access to the most important power
parameters.
The "Power" measurement can be performed with a wide range of IF filters of various
shapes and bandwidths. In addition to Gaussian and bandpass filters, the
measurement provides special filter types for WCDMA and CDMA200 measurements.
7.1.2.5 Power: Results
The basic "Power" measurement result is the power of the RF input signal averaged
over the "Measurement Length". All power results of the sweep can be displayed in a
bar graph or in tables. Moreover, the measurement provides a statistical evaluation at
a particular power step; see Statistical Results.
The statistical evaluation includes the calculation of the "Standard Deviation". This
quantity shows how widely spread the power values are at each power step.
To Next Page
Loading...
