R&S
®
CMW 500 Basic Instrument Functions
Measurements
Operating Manual 1202.3986.32 – 03 53
4 Basic Instrument Functions
The following chapter describes dialogs and settings for general use. The dialogs are
not related to a particular general purpose or network test application.
4.1.1 Startup Dialog
The "Startup" dialog shows the progress of the startup procedure and the available
options. Once the startup procedure has been terminated, it is automatically replaced
by the measurement or generator dialog opened in the last session.
Startup dialog
The "Startup" dialog provides control softkeys that you can activate while the startup is
in progress.
Cold Boot
Copies new firmware-specific data to the internal hardware of the R&S CMW 500. A
cold boot is required to finalize a firmware update.
Continue / Wait
Resume or interrupt the startup procedure. "Wait" is appropriate e.g. for a check of the
installed hardware and software options; see "Progress Info / Detailed Info" below.
To Next Page
Loading...
