Need help?Do you have a question about the Rohde & Schwarz CMW500 and is the answer not in the manual?
General| Modulation Bandwidth | Up to 160 MHz |
|---|---|
| Number of RF Ports | Up to 4 |
| Power Supply | 100-240 V AC, 50/60 Hz |
| Modulation Types | AM, FM, PM |
| Number of RF Channels | Up to 4 |
| Measurement Functions | EVM, spectrum analysis, and more |
| Interface | GPIB, LAN, USB |
Covers essential steps for initial setup, including unpacking, positioning, and starting the R&S CMW500.
Details manual and remote operation, including GUI control via mouse, keyboard, or front panel.
Provides guidelines for instrument cleaning, storage, packing, and fuse replacement.
Central dialog for performing basic and administrative tasks, including system and remote settings.
Configures splitting the instrument into sub-instruments and assigning hardware/software resources.
Details setting up the tester for remote control, including interfaces, protocols, and LAN connection testing.
Explains the structure of remote commands, firmware applications, and measurement contexts.
Covers control of measurement, generator, and signaling applications, including states and substates.
Illustrates how remote commands are serviced within the instrument.
Details the status reporting system, hierarchy of registers, and error indicators.
Explains the use of macros for saving transfer time and speeding up measurements via remote control.
Details commands for mass memory, error queue, reset/preset, and tracing remote interfaces.
To Next Page