Getting Started
R&S
®
CMW500
16User Manual 1173.9463.02 ─ 06
The patch cable may also be required when using the R&S CMW500 as system com-
ponent in R&S CMW-RRM or R&S TS8980 test systems. For more information, refer to
the documentation provided with these products.
Plug the cable into connector 1 of the LAN SWITCH and into the LAN REMOTE connector
as shown in the following figure.
Fig. 2-1: Ethernet connection between LAN SWITCH and LAN REMOTE connectors
The patch cable is only functional if the "Lan Remote" network adapter is integrated into
the internal IPv4 subnet of the instrument.
For configuration of a compatible "Lan Remote" IP address, see chapter 4.4.9, "IP Subnet
Configuration", on page 101.
2.2 Instrument Tour
This chapter provides an overview of the control elements and connectors of the instru-
ment and explains how to connect external devices.
2.2.1 Front Panel Tour
The front panel of the R&S CMW500 with display consists of the VGA display with the
softkey and hotkey areas, the utility keys to the left, the hardkey area to the right, the RF/
AF connectors and the control interfaces.
Brief explanations on the controls and connectors of the front panel can be found in the
following sections.
Instrument Tour
To Next Page
Loading...
