Rohde & Schwarz CMW500 - Configure:base:fdcorrection:ctable:delete; Configure:base:fdcorrection:ctable:erase

Command Reference - Base Software
R&S
®
CMW500
228User Manual 1173.9463.02 ─ 06
<Correction> Range: -50 dB to 90 dB
Increment: 0.01 dB
Default unit: dB
Example:
CONFigure:BASE:FDCorrection:CTABle:ADD
'mytable', 1925000000, 0.55, 1975000000, 0.65
Add two entries to the table 'mytable': 0.55 dB at 1925 MHz
and 0.65 dB at 1975 MHz
Usage: Event
Firmware/Software: V1.0.5.3
CONFigure:
BASE:FDCorrection:CTABle:ERASe <TableName>, <Frequency>...
Removes one or more selected entries from a correction table. Each table entry consists
of a frequency value and a correction value. Entries to be removed are selected via their
frequency values.
Setting parameters:
<TableName> String parameter identifying the table. To display a list of existing
tables use the command
CONFigure:BASE:FDCorrection:CTABle:CATalog?.
<Frequency> Selects the table entry to be removed. The value must match the
frequency of an existing table entry. To remove several entries,
specify a comma-separated list of frequencies.
Range: 100E+6 Hz to 6E+9 Hz
Increment: 0.1 Hz
Default unit: Hz
Example:
CONFigure:BASE:FDCorrection:CTABle:ERASe
'mytable', 1925000000, 1975000000
The two entries with the frequencies 1925 MHz and 1975 MHz are
removed from the table 'mytable'.
Usage: Event
Firmware/Software: V2.1.27
CONFigure:BASE:FDCorrection:CTABle:DELete <TableName>
Deletes a correction table from the hard disk.
Setting parameters:
<TableName> String parameter identifying the table. To display a list of existing
tables use the command
CONFigure:BASE:FDCorrection:CTABle:CATalog?.
Example:
CONFigure:BASE:FDCorrection:CTABle:DELete
'mytable'
Usage: Event
Instrument-Control Commands