Rohde & Schwarz CMW500 - Reset and Preset

Command Reference - Base Software
R&S
®
CMW500
207User Manual 1173.9463.02 ─ 06
Example:
SYSTem:ERRor?
Query the oldest entry in the error queue. 0,"No error" is returned
if the error queue is empty.
Usage: Query only
SCPI confirmed
Firmware/Software: V1.0.0.4
6.3.5 Reset and Preset
The following commands reset or preset the instrument or specific software parts.
SYSTem:PRESet:ALL....................................................................................................207
SYSTem:RESet:ALL......................................................................................................207
SYSTem:PRESet:BASE.................................................................................................207
SYSTem:RESet:BASE...................................................................................................207
SYSTem:PRESet...........................................................................................................208
SYSTem:RESet.............................................................................................................208
SYSTem:PRESet:ALL
SYSTem:RESet:ALL
A PRESet sets the parameters of all sub-instruments and the base settings to default
values suitable for local/manual interaction. A RESet sets them to default values suitable
for remote operation.
Example:
SYSTem:PRESet:ALL
Force the entire R&S CMW500 to a preset state optimized for
manual operation.
Usage: Event
Firmware/Software: V1.0.5.3
SYSTem:PRESet:BASE
SYSTem:RESet:BASE
A PRESet sets the base settings to default values suitable for local/manual interaction.
A RESet sets them to default values suitable for remote operation.
Example:
SYSTem:PRESet:BASE
Force the base settings to a preset state optimized for manual
operation.
Usage: Event
Firmware/Software: V1.0.5.3
Instrument-Control Commands