Basic Instrument Functions
R&S
®
CMW500
80User Manual 1173.9463.02 ─ 06
Factory Default
Sets the instrument to its factory default state.
This state comprises the following settings:
● All Preset settings: The instrument is optimized for local/manual operation.
●
The address information assigned to the instrument (e.g. the IP address or USB
product ID/vendor ID/device ID).
●
The instrument setup: One sub-instrument.
Continue / Wait
Resume or interrupt the startup procedure. "Wait" is appropriate e.g. for a check of the
installed hardware and software options; see "Progress Info / Detailed Info" below.
Progress / Detailed
Toggles between alternative information types in the "Option/progress information" panel
across the bottom of the screen.
●
The "Progress Info" is a log of the startup procedure including the loaded software
components.
●
The "Detailed Info" describes the selected hardware or software option. It may contain
the name, version, product code and essential technical data of the option.
It is preferable to press "Continue / Wait" in order to view the "Detailed Info". After the
startup procedure is finished and the startup dialog is closed, the detailed option infor-
mation can be accessed via the "Setup" dialog, see chapter 4.4.4, "SW/HW Equip-
ment", on page 90.
Abort
Aborts the startup procedure. The R&S CMW500 returns to standby state. Press the
standby key on the front panel to re-initialize the startup. See also chapter 2.2.1.3,
"Standby Key", on page 18.
4.2 Reset Dialog
The "Reset" dialog forces the instrument to return to a definite reset/preset state.
To open the dialog press the RESET key at the (soft-)front panel.
Reset Dialog
To Next Page
Loading...
