Rohde & Schwarz CMW500 - System Date and Time

Command Reference - Base Software
R&S
®
CMW500
278User Manual 1173.9463.02 ─ 06
STATus:QUEStionable:BIT<n>:ENABle <BitValue>
STATus:QUEStionable:BIT<n>:NTRansition <BitValue>
STATus:QUEStionable:BIT<n>:PTRansition <BitValue>
Sets bit no. <n> of the ENABle, NTRansition or PTRansition part of the STATus:QUES-
tionable register, see also Structure of an SCPI Status Register. To set the entire parts
see STATus:QUEStionable:ENABle, STATus:QUEStionable:NTRansition and
STATus:QUEStionable:PTRansition.
Suffix:
<n>
.
8 to 12
Number of the bit
Parameters:
<BitValue> 0 | 1
Example:
STAT:QUES:OPER:BIT9:ENAB 1
Set bit no. 9 of the ENABle part of the STATus:QUEStionable reg-
ister.
Firmware/Software: V1.0.4.11
6.3.14 System Date and Time
The following commands configure or query the date and time settings of the operating
system. Note that *RST does not affect these settings.
SYSTem:DATE[:UTC]....................................................................................................278
SYSTem:DATE:LOCal....................................................................................................279
SYSTem:TIME[:UTC].....................................................................................................279
SYSTem:TIME:LOCal.....................................................................................................279
SYSTem:TIME:DSTime:MODE.......................................................................................279
SYSTem:TIME:DSTime:RULE:CATalog?.........................................................................280
SYSTem:TIME:DSTime:RULE.........................................................................................280
SYSTem:TZONe............................................................................................................281
SYSTem:DATE[:UTC] <Year>, <Month>, <Day>
Sets the UTC date of the operating system calendar.
Parameters:
<Year> Range: four-digit number
<Month> Range: 1 to 12
<Day> Range: 1 to n (depending on the <Month>)
Example:
SYSTem:DATE:UTC?
Query the UTC date. Possible response: 2012, 09, 19
Firmware/Software: V3.0.12
Instrument-Control Commands