Rohde & Schwarz CMW500 - Buffer Commands

Command Reference - Base Software
R&S
®
CMW500
201User Manual 1173.9463.02 ─ 06
'<MacroFile>' String parameter specifying path and filename of the destination
file (on the instrument)
Example:
See Macro Programming Examples
Usage: Event
SCPI confirmed
Firmware/Software: V2.1.10
SYSTem:RECord:MACRo:FILE:STARt '<MacroFile>'
Starts recording of submitted commands into the specified macro file. To stop recording,
see SYSTem:RECord:MACRo:FILE:STOP.
Parameters:
'<MacroFile>' String parameter specifying path and filename of the destination
file (on the instrument)
Example:
See Macro Programming Examples
Usage: Event
Firmware/Software: V2.1.10
SYSTem:RECord:MACRo:FILE:STOP
Stops recording of commands into a macro file. To start recording, see SYSTem:
RECord:MACRo:FILE:STARt.
Example:
See Macro Programming Examples
Usage: Event
Firmware/Software: V2.1.10
6.3.2 Buffer Commands
The following remote control commands are related to response buffers. The command
syntax follows the general R&S CMW500 syntax rules; the commands are not SCPI
confirmed.
CLEar:BASE:BUFFer.....................................................................................................202
CONTinue:BASE:BUFFer...............................................................................................202
DELete:BASE:BUFFer....................................................................................................202
FETCh:BASE:BUFFer?..................................................................................................202
FETCh:BASE:BUFFer:LINecount?...................................................................................203
STARt:BASE:BUFFer.....................................................................................................203
STOP:BASE:BUFFer......................................................................................................203
Instrument-Control Commands