Rohde & Schwarz CMW500 - System: C Ommunicate: N ET: S Ubnet: M ASK; System: C Ommunicate: N ET: G Ateway; System: C Ommunicate: N ET: D NS: E Nable

Command Reference - Base Software
R&S
®
CMW500
236User Manual 1173.9463.02 ─ 06
SYSTem:COMMunicate:NET:SUBNet:MASK '<Mask>'...
Defines the subnet masks to be used for the network adapter addresses. This is only
relevant if DHCP is disabled (SYSTem:COMMunicate:NET:DHCP).
A query returns the currently used subnet masks, irrespective of whether they have been
assigned manually or via DHCP.
Parameters:
'<Mask>' String parameter, subnet mask consisting of four blocks separated
by dots
Several strings separated by commas can be entered or several
masks separated by commas can be included in one string.
*RST: a *RST does not affect the LAN service settings
Example:
SYSTem:COMMunicate:NET:SUBNet:MASK
'255.255.0.0'
Sets subnet mask 255.255.0.0.
Firmware/Software: V1.0.0.4
V3.0.10: support of more than one subnet mask
SYSTem:COMMunicate:NET:GATeway '<Address>'...
Defines IPv4 addresses of default gateways. This is only relevant if DHCP is disabled (
SYSTem:COMMunicate:NET:DHCP).
A query returns the currently defined addresses, irrespective of whether they have been
specified manually or via DHCP.
Parameters:
'<Address>' String parameter, gateway IP address consisting of four blocks
separated by dots
Several strings separated by commas can be entered or several
addresses separated by commas can be included in one string.
*RST: a *RST does not affect the LAN service settings
Example:
SYSTem:COMMunicate:NET:GATeway '10.113.0.1'
Sets the default gateway address to 10.113.0.1.
Firmware/Software: V1.0.0.4
V3.0.10: support of more than one address
SYSTem:COMMunicate:NET:DNS:ENABle <Boolean>
Enables or disables dynamic configuration of DNS server addresses.
Parameters:
<Boolean> -1 | 0
-1: Enabled, automatic configuration
0: Disabled, manual configuration
*RST: a *RST does not affect the LAN service settings
Instrument-Control Commands