System Overview
R&S
®
CMW500
75User Manual 1173.9463.02 ─ 06
► To turn the signaling generator on or off, select the signaling control softkey and press
ON | OFF.
As soon as an output signal is available at the selected connector, the control softkey
indicates the "ON" state:
The "RDY" state indicates that the signaling application is ready to receive a handover
from another signaling application.
This state is entered when the signaling application has been selected as handover target
in another signaling application and all preparations for reception of the handover have
been completed. In the "RDY" state, an output signal may be available or not, depending
on whether both signaling applications use the same or different resources.
"Pending" state
Depending on the signaling application and its configuration, the R&S CMW500 may
require some time to provide the generator signal.
While the signaling generator is turned on but still waiting for resource allocation, adjust-
ment, hardware switching, a yellow sandglass symbol in the control softkey indicates the
"pending" state.
The yellow symbol disappears as soon as the signaling generator signal is available.
The "pending" state is also indicated while the signaling generator is turned off but the
resources have not yet been released.
3.3.3 Connection States
After the cell signal is available, the mobile station under test can synchronize to the signal
and attempt a registration so that it is possible to set up a network connection. The con-
nection states and state transitions are network-specific; refer to the description of the
individual signaling application.
When the connection is established, the R&S CMW500 is ready to perform signaling
tests.
Signaling Applications
To Next Page
Loading...
