Rohde & Schwarz CMW500 - System Settings

Basic Instrument Functions
R&S
®
CMW500
85User Manual 1173.9463.02 ─ 06
4.4.1 System Settings
The "System" section of the "Setup" dialog defines the overall appearance of the dialogs,
address information for remote control and settings for remote software update. It also
provides access to a configuration dialog of the data application unit (if installed).
Fig. 4-5: Setup - System
Display
Configures the look of the GUI at the display.
Remote command:
SYSTem:BASE:DISPlay:FONTset
Lan Services
The available network adapters can be configured independently. One is accessed via
the LAN connector on the front panel, the other via the LAN REMOTE connector on the
rear panel. The names of the network adaptera are"Lan Front" and "Lan Remote".
Some applications provided by the instrument need a specific "Lan Remote" IP address.
For details see chapter 4.4.9, "IP Subnet Configuration", on page 101.
Remote command:
SYSTem:COMMunicate:NET:...
See chapter 6.3.10.1, "System Settings", on page 234
Setup Dialog