Rohde & Schwarz CMW500 - 6.3 Instrument-Control Commands; Instrument-Control Commands; Macro Commands

Command Reference - Base Software
R&S
®
CMW500
197User Manual 1173.9463.02 ─ 06
Code Meaning Effect on the instrument
&ABO
&BRK
&DCL
(Abort)
(Break)
(Device Clear)
Aborts processing of the commands just received and sets the
command processing software to a defined initial state. Does not
change the instrument setting.
&GTL (Go to Local) Transition to the "Local" state (manual control).
&GET (Group Execute Trigger) Triggers a previously active device function (e.g. a sweep). The
effect of the command is the same as with that of a pulse at the
external trigger signal input.
&GTR (Go to Remote) Transition to the "Remote" state (remote control).
&LLO (Local Lockout) Disables switchover from remote control to manual control by
means of the front panel keys or remote commands.
&NREN
&RLSD
(Not Remote Enable) Enables switchover from remote control to manual control by
means of the front panel keys or remote commands.
&POL (Serial Poll) Starts a serial poll.
6.3 Instrument-Control Commands
The instrument-control commands for the R&S CMW500 platform give access to the
mass memory, control the status structures, and perform various administrative tasks.
The platform commands are divided into the command groups listed below.
● Macro Commands.................................................................................................197
● Buffer Commands.................................................................................................201
● High Resolution Timer...........................................................................................204
● Error Queue..........................................................................................................205
● Reset and Preset..................................................................................................207
● Tracing the Remote Control Interface...................................................................208
● Mass Memory Commands....................................................................................212
● Hardcopy Commands...........................................................................................224
● Frequency-Dependent Correction.........................................................................225
● Setup Commands.................................................................................................234
● Sub-Instruments....................................................................................................252
● Calibration Commands..........................................................................................253
● Status Reporting System......................................................................................255
● System Date and Time..........................................................................................278
● Miscellaneous Instrument Settings.......................................................................281
6.3.1 Macro Commands
The following remote control commands are related to macro files and macro execution.
All macro commands are SCPI-confirmed.
Instrument-Control Commands