Rohde & Schwarz CMW500 - Activating Options

Basic Instrument Functions
R&S
®
CMW500
89User Manual 1173.9463.02 ─ 06
Enabled (IEC only)
Enables or disables a GPIB remote channel. Up to four channels are available. Two sub-
instruments can be controlled using/enabling either two channels of one board or one
channel per board.
Remote command:
SYSTem:COMMunicate:GPIB<i>[:SELF]:ENABle
4.4.3 Activating Options
New R&S CMW500 options must be enabled using the key code supplied by Rohde &
Schwarz.
Activating a previously installed option involves the following steps:
1. Open the "License Keys" section in the "Setup" dialog.
2. Enter the key code using either manual activation, typing in the key code, or an
installation file.
3.
Restart the R&S CMW500.
The "Setup" dialog provides all necessary control elements and shows the active, deac-
tivated and invalid license keys.
Fig. 4-7: Setup – License Keys
Setup Dialog