Rohde & Schwarz CMW500 - Generator;Signaling Controller Dialog; Measurement Controller Dialog

Basic Instrument Functions
R&S
®
CMW500
111User Manual 1173.9463.02 ─ 06
4.8 Measurement Controller Dialog
The "Measurement Controller" dialog lists the available measurement firmware applica-
tions and allows to add measurement applications to the task bar.
To open the dialog press the MEASURE key at the (soft-)front panel.
Fig. 4-21: Measurement Controller dialog
Use the checkboxes in the dialog to add or remove a task bar entry for a measurement.
For manual control of a firmware application, the application must be added to the task
bar. Remote control of a firmware application is possible without a corresponding task
bar entry.
4.9 Generator/Signaling Controller Dialog
The "Generator/Signaling Controller" dialog lists the available generator and signaling
firmware applications and allows to add the applications to the task bar.
To open the dialog press the SIGNAL GEN key at the (soft-)front panel.
Fig. 4-22: Generator/Signaling Controller dialog
Use the checkboxes in the dialog to add or remove a task bar entry for a generator or
signaling application.
For manual control of a firmware application, the application must be added to the task
bar. Remote control of a firmware application is possible without a corresponding task
bar entry.
Measurement Controller Dialog