Rohde & Schwarz CMW500 - Remote Settings

Basic Instrument Functions
R&S
®
CMW500
86User Manual 1173.9463.02 ─ 06
Data Appl. Control
If a Data Application Unit (DAU) is installed, "Go to config" opens the "Data Application
Control" dialog which lets you configure data testing IP services of the DAU. For more
details, refer to the description of the "Data Application Unit".
The DAU is only available for R&S CMW500.
Remote command:
n/a
Software Update
The "Device Group" must match the settings in the "R&S Software Distributor" in order
to perform a remote software update.
Remote command:
SYSTem:UPDate:DGRoup
User Mode
The user mode can be changed using the softkey "User Mode Login".
●
The "User" mode provides the complete measurement functionality of the
R&S CMW500 and most selftests.
● The "User (Extended)" mode provides additional RAM and cable selftests; see e.g. 
"External Tests" on page 94.
●
The remaining user modes are for service purposes.
Remote command:
n/a
4.4.2 Remote Settings
The "Remote" section of the "Setup" dialog lists all available interface and protocol types
for remote control of the instrument and their parameters.
The highest level lists the interface and protocol types:
●
HI-SLIP (LAN connector, HiSLIP protocol)
●
VXI-11 (LAN connector, VXI-11 protocol)
●
IEC (GPIB bus interface, option R&S CMW-B612A or R&S CMW-B612B)
●
USB2 ("USB Remote" connector)
●
TCPIP (LAN connector, VISA socket resource)
For remote control via LAN it is recommended to use the HiSLIP protocol.
The entries at the second level correspond to one remote channel each. Each channel
is assigned to one sub-instrument. Several channels can be used in parallel. The number
of available channels depends on the protocol type and on the installed options.
See also chapter 5.1.5, "Multiple Channels for Remote Access", on page 123
Setup Dialog