Rohde & Schwarz CMW500 - 6.3.10 Setup Commands; Setup Commands; System: B ASE: D Isplay: F Ontset; System: C Ommunicate: N ET: a Dapter

Command Reference - Base Software
R&S
®
CMW500
234User Manual 1173.9463.02 ─ 06
6.3.10 Setup Commands
The commands described in this section configure or query parameters that are also
present in the "Setup" dialog of the instrument.
See also chapter 4.4, "Setup Dialog", on page 84.
6.3.10.1 System Settings
The following commands configure settings related to the display, the LAN connection
and software updates. The settings are also available in the "System" section of the
"Setup" dialog.
SYSTem:BASE:DISPlay:FONTset...................................................................................234
SYSTem:COMMunicate:NET:ADAPter.............................................................................234
SYSTem:COMMunicate:NET:HOSTname?.......................................................................235
SYSTem:COMMunicate:NET:DHCP................................................................................235
SYSTem:COMMunicate:NET:IPADdress..........................................................................235
SYSTem:COMMunicate:NET:SUBNet:MASK....................................................................236
SYSTem:COMMunicate:NET:GATeway...........................................................................236
SYSTem:COMMunicate:NET:DNS:ENABle......................................................................236
SYSTem:COMMunicate:NET:DNS...................................................................................237
SYSTem:UPDate:DGRoup..............................................................................................237
SYSTem:BASE:DISPlay:FONTset <FontSize>
Selects the font size for the GUI labels.
Parameters:
<FontSize> DEF | LRG
DEF: Small fonts
LRG: Large fonts
*RST: DEF
Example:
SYSTem:BASE:DISPlay:FONTset LRG
Select large fonts.
Firmware/Software: V1.0.5.3
SYSTem:COMMunicate:NET:ADAPter '<Adapter>'
Selects the network adapter and thus the connection type to be modified. All
SYSTem:COMMunicate:NET:... commands affect the selected network adapter. This
command does not activate or deactivate a network adapter. At present only LAN con-
nections are supported.
Parameters:
'<Adapter>' String parameter, 'Lan Remote' or 'Lan Front'
*RST: a *RST does not affect the LAN service settings
Example:
SYSTem:COMMunicate:NET:ADAPter "Lan Remote"
Selects the "Lan Remote" network adapter.
Instrument-Control Commands