Basic Instrument Functions
R&S
®
CMW500
82User Manual 1173.9463.02 ─ 06
Reset
Sets the instrument parameters to values suitable for remote operation.
In particular, the reset state comprises the following settings:
●
All measurements are performed in Single-Shot mode ("Repetition: Single-Shot").
● The R&S CMW500 uses short statistics cycles (for benchmarks).
●
In multi evaluation measurements, some time-consuming evaluations are skipped to
gain measurement speed.
The following R&S CMW500 settings are not affected by a reset:
●
Address information assigned to the instrument (e.g. the IP address)
●
The instrument setup
●
The contents of the status registers
Remote command:
*RST
SYSTem:RESet etc.
See chapter 6.3.5, "Reset and Preset", on page 207
4.3 Save/Recall Dialog
The "Save/Recall" dialog stores the current instrument setup and recalls setups.
To open the dialog press the SAVE key at the (soft-)front panel.
Save/Recall Dialog
To Next Page
Loading...
