Basic Instrument Functions
R&S
®
CMW500
81User Manual 1173.9463.02 ─ 06
Fig. 4-2: Dialog for 1 sub-instrument
Fig. 4-3: Dialog for several sub-instruments
The reset/preset can be performed for the entire R&S CMW500 or it can be limited to the
current firmware application.
If the R&S CMW500 has been split into sub-instruments, the reset/preset can also be
limited to the current sub-instrument.
In addition to the reset and preset states described here, the instrument supports also a
factory default state, see "Factory Default" on page 80.
Preset
Sets the instrument parameters to values suitable for local/manual interaction.
In particular, the preset state comprises the following settings:
●
All measurements are repeated continuously ("Repetition: Continuous").
● The R&S CMW500 uses long statistics cycles (for reliable statistical evaluations).
The following R&S CMW500 settings are not affected by a preset:
●
Address information assigned to the instrument (e.g. the IP address)
●
The instrument setup
Remote command:
SYSTem:PRESet etc.
See chapter 6.3.5, "Reset and Preset", on page 207
Reset Dialog
To Next Page
Loading...
