Rohde & Schwarz CMW500 - Calibration Commands

Command Reference - Base Software
R&S
®
CMW500
253User Manual 1173.9463.02 ─ 06
SYSTem:BASE:DEVice:RESet
Assigns the available hardware resources to the sub-instrument(s). This command has
to be entered after the number of sub-instruments has been changed via
SYSTem:BASE:DEVice:COUNt 2.
Usage: Event
Firmware/Software: V1.0.5.3
SYSTem:BASE:DEVice:SUBinst?
Queries the number of the addressed sub-instrument and the total number of sub-instru-
ments.
Return values:
<CurSubInst> Number of the addressed sub-instrument, as indicated in a VISA
resource string for VXI-11
0: instrument 1
1: instrument 2
<SubInstCount> Total number of sub-instruments
1: all hardware resources are assigned to a single sub-instrument
2: the physical instrument is split into two sub-instruments
Example:
SYSTem:BASE:DEVice:SUBinst?
Returns 0,1 or 0,2 or 1,2.
Usage: Query only
Firmware/Software: V2.0.10
6.3.12 Calibration Commands
The following commands query information related to performed calibrations of the
R&S CMW500.
CALibration:BASE:ALL?.................................................................................................253
CALibration:BASE:LATest?.............................................................................................254
CALibration:BASE:LATest:SPECific?...............................................................................254
CALibration:BASE:ACFile?.............................................................................................255
CALibration:BASE:ALL?
Query the stored calibration information. A comma separated list is returned, containing
three parameters per calibration, as described below.
Return values:
<Date> Date of the calibration as string
<Time> Time of the calibration as string
Instrument-Control Commands