Command Reference - Base Software
R&S
®
CMW500
237User Manual 1173.9463.02 ─ 06
Example:
SYSTem:COMMunicate:NET:DNS:ENABle 0
Disables dynamic/automatic DNS server address configuration.
Firmware/Software: V1.0.0.4
SYSTem:COMMunicate:NET:DNS '<Address>'...
Defines the DNS server IPv4 addresses to be used. The addresses are valid if
dynamic configuration is disabled (SYSTem:COMMunicate:NET:DNS:ENABle).
A query returns the defined DNS addresses, irrespective of whether they have been
specified manually or via DHCP.
Parameters:
'<Address>' String parameters, DNS server addresses consisting of four
blocks separated by dots
Several strings separated by commas can be entered or several
addresses separated by commas can be included in one string.
*RST: a *RST does not affect the LAN service settings
Example:
SYSTem:COMMunicate:NET:DNS '10.0.2.166',
'10.0.23.159'
Use 10.0.2.166 for primary DNS server and 10.0.23.159 for sec-
ondary DNS server.
Firmware/Software: V1.0.0.4
V3.0.10: support of more than two addresses
SYSTem:UPDate:DGRoup <DeviceGroup>
Sets the "Device Group" the instrument belongs to. For remote installation, this setting
must match the corresponding setting in the R&S Software Distributor options.
Parameters:
<DeviceGroup> Device group as string.
Example:
SYSTem:UPDate:DGRoup "MyInstrument"
Set the device group to "MyInstrument".
Firmware/Software: V1.0.0.4
6.3.10.2 Remote Settings
The following commands define the address information for the different remote-control
interfaces of the R&S CMW500. The settings are also available in the "Remote" section
of the "Setup" dialog.
SYSTem:COMMunicate:HISLip<i>:VRESource?...............................................................238
SYSTem:COMMunicate:SOCKet<i>:MODE......................................................................238
SYSTem:COMMunicate:SOCKet<i>:PORT.......................................................................238
SYSTem:COMMunicate:SOCKet<i>:VRESource?.............................................................239
SYSTem:COMMunicate:GPIB<i>[:SELF]:ADDR................................................................239
SYSTem:COMMunicate:GPIB<i>[:SELF]:ENABle..............................................................240
Instrument-Control Commands