Command Reference - Base Software
R&S
®
CMW500
238User Manual 1173.9463.02 ─ 06
SYSTem:COMMunicate:GPIB<i>:VRESource?.................................................................240
SYSTem:COMMunicate:USB:VRESource?.......................................................................240
SYSTem:COMMunicate:VXI<i>:GTR...............................................................................241
SYSTem:COMMunicate:VXI<i>:VRESource?...................................................................241
SYSTem:COMMunicate:HISLip<i>:VRESource?
Queries the VISA resource string for the HiSLIP protocol; see Remote Control Opera-
tion.
Suffix:
<i>
.
1..2
Selects the remote channel.
Return values:
'<String>' VISA address string; see example below.
*RST: *RST has no effect on the value. The address string
depends on the host name; see example below.
Example:
SYSTem:COMMunicate:NET:HOSTname 'hh346999'
SYSTem:COMMunicate:HISLip2:VRESource?
Define a host name and query the VISA resource string for the
HiSLIP protocol (channel 2). The response is
'TCPIP::hh346999::hislip1::INSTR'.
Usage: Query only
Firmware/Software: V3.0.10
SYSTem:COMMunicate:SOCKet<i>:MODE <Mode>
Sets the protocol operation mode for direct socket communication.
Suffix:
<i>
.
1..2
Selects the remote channel.
Parameters:
<Mode> RAW | AGILent | IEEE1174
RAW: no support of control messages, e.g. polling or service
request
AGILent: emulation codes via control connection (control port)
IEEE1174: emulation codes via data connection (data port
*RST: a *RST has no effect on this parameter
Example:
SYSTem:COMMunicate:SOCKet:MODE RAW
Set the operation mode to raw TCP/IP.
Firmware/Software: V1.0.5.3
SYSTem:COMMunicate:SOCKet<i>:PORT <Port>
Sets the port number for direct socket communication.
Instrument-Control Commands
To Next Page
Loading...
