Need help?Do you have a question about the Rohde & Schwarz CMW500 1201.0002K50 and is the answer not in the manual?
General| RF Generator Ports | Up to 2 |
|---|---|
| RF Analyzer Ports | Up to 2 |
| LTE FDD/TDD | Supported |
| WCDMA/HSPA/HSPA+ | Supported |
| GSM/EDGE | Supported |
| CDMA2000 1xRTT/EV-DO | Supported |
| WLAN IEEE 802.11 a/b/g/n/ac | Supported |
| Maximum RF Bandwidth | Up to 160 MHz |
| Number of RF Ports | 4 |
| Interfaces | GPIB, LAN, USB |
| Power Supply | 100 V to 240 V AC |
| Signal Generation | Supported |
| Signal Analysis | Yes |
| Storage Temperature Range | -40 °C to +70 °C |
Covers essential steps for initial instrument setup and connection.
Covers the procedures for powering on and off the instrument.
Details how to integrate the instrument into a network for remote control.
Covers procedures for updating the instrument's software packages.
Details the step-by-step process for installing software updates.
Helps users perform common tasks efficiently using the GUI and control elements.
Details how to enter numeric values and characters using the front panel or external keyboard.
Provides practical examples of generating and measuring RF signals.
Explains how to configure the generator to produce RF signals.
Demonstrates how to perform RF signal measurements using the GPRF Power measurement.
Covers measurements related to transmitter performance.
Covers measurements related to receiver performance.
Explains how to reset the instrument to a definite state or factory defaults.
A central dialog for performing basic and administrative tasks.
Explains how to enable new instrument options using key codes.
Provides extensive selftest procedures for modules and the system.
Explains how to set up the tester for remote control via various interfaces.
Details the structure and syntax rules for SCPI commands.
Covers control of measurement, generator, and signaling applications.
Explains generator states (OFF, PENDING, ON) and control commands.
Details measurement states and control commands.
Lists commands for mass memory, status structures, and administrative tasks.
Covers functions not related to instrument performance.
To Next Page