Basic Instrument Functions
R&S
®
CMW500
112User Manual 1173.9463.02 ─ 02
See also: Resource and Path Management
SCPI command:
SYSTem:BASE:DEVice:COUNt
SYSTem:BASE:DEVice:RESet
SYSTem:BASE:DEVice:SUBinst
Go to Sub Instrument 1/2
These buttons are available if "Two Sub Instruments" is selected. They select the current
sub-instrument for manual control. Remote control of the sub-instruments is independent
of this setting.
In order to facilitate the distinction between the two sub-instruments, the GUIs of the sub-
instruments use different colors for the background and the active softkeys and hotkeys.
These colors correspond to the colors of the "Go to Instrument 1/2" buttons.
SCPI command:
n/a
5.5 Measurement Controller Dialog
The "Measurement Controller" dialog gives an overview of the available measurement
firmware applications. It also configures the task bar; see Configuring the Task Bar.
To open the dialog press MEASURE.
Fig. 5-19: Measurement Controller dialog
► Use the checkboxes in the dialog to display or hide a taskbar entry for a measure-
ment.
Notice that up to 8 firmware applications can be active (displayed in the taskbar) simul-
taneously. Remote control of a firmware application is possible without corresponding
active taskbar entry.
Measurement Controller Dialog
To Next Page
Loading...
