Rohde & Schwarz CMW500 1201.0002K50 - Recovering the Factory Default Settings; Handling User-Defined Images

Annexes
R&S
®
CMW500
280User Manual 1173.9463.02 ─ 02
Fig. 8-5: Recovery and Backup dialog
8.3.2 Recovering the Factory Default Settings
The "Factory Default" image is always available on the backup/restore partition; it cannot
be deleted.
To restore the initial state of the instrument, recover the "Factory Default" image.
1. In the "Recovery an Backup" dialog, activate "Factory Default".
2. In the dialog opened, confirm recovery and wait until the system image has been
replaced by the "Factory Default" image.
8.3.3 Handling User-Defined Images
Creating backup versions of the sytem image, restoring and removing backup versions
is self-explanatory. Use the buttons in the "Recovery an Backup" dialog.
Windows XP Recovery and Backup