Basic Instrument Functions
R&S
®
CMW500
98User Manual 1173.9463.02 ─ 02
Enabled (IEC only)
Enables or disables a GPIB remote channel. Up to four channels are available. Two sub-
instruments can be controlled using/enabling either two channels of one board or one
channel per board.
SCPI command:
SYSTem:COMMunicate:GPIB<i>[:SELF]:ENABle
5.3.3 Activating Options
New R&S CMW500 options must be enabled using the key code supplied by Rohde &
Schwarz. Activating a previously installed option involves the following steps.
1. Open the "License Keys" section in the "Setup" dialog.
2. Enter the key code using either manual activation, typing in the key code, or an
installation file.
3. Restart the R&S CMW500
The "Setup" dialog provides all necessary control elements and shows the active, deac-
tivated and invalid license keys.
Fig. 5-10: Setup – License Keys
Setup Dialog
To Next Page
Loading...
