Rohde & Schwarz CMW500 1201.0002K50 - Instrument-Control Commands; Macro Commands

Command Reference
R&S
®
CMW500
196User Manual 1173.9463.02 ─ 02
Code Meaning Effect on the instrument
&LLO (Local Lockout) Disables switchover from remote control to manual control by
means of the front panel keys or remote commands.
&NREN
&RLSD
(Not Remote Enable) Enables switchover from remote control to manual control by
means of the front panel keys or remote commands.
&POL (Serial Poll) Starts a serial poll.
7.3 Instrument-Control Commands
The instrument-control commands for the R&S CMW500 platform give access to the
mass memory, control the status structures, and perform various administrative tasks.
The platform commands are divided into the command groups listed below.
● Macro Commands.................................................................................................196
● Buffer Commands.................................................................................................199
● Frequency-Dependent Correction Settings...........................................................201
● CALibration Commands........................................................................................206
● FORMat Commands.............................................................................................208
● MMEMory Commands..........................................................................................209
● STATus Commands..............................................................................................219
● SYSTem Commands............................................................................................241
● TRACe Commands...............................................................................................260
● TRIGger Commands.............................................................................................264
7.3.1 Macro Commands
The following remote control commands are related to macro files and macro execution.
All macro commands are SCPI-confirmed.
R&S CMW500-specific command properties
The following macro command properties differ from SCPI stipulations:
●
The *RST state of *EMC is OFF. Macro execution must be enabled deliberately for
every remote connection.
●
Normal remote control execution has priority over macro execution. Macros which
have the same name as a remote command supported by the R&S CMW500 are
ignored.
*DMC............................................................................................................................197
*EMC............................................................................................................................197
*GMC...........................................................................................................................198
*LMC............................................................................................................................198
*PMC............................................................................................................................198
*RMC............................................................................................................................198
MMEMory:LOAD:MACRo................................................................................................199
Instrument-Control Commands