Rohde & Schwarz CMW500 1201.0002K50 - LAN Services

Command Reference
R&S
®
CMW500
244User Manual 1173.9463.02 ─ 02
Parameters:
<Enable> ON | OFF
ON: Display is shown and updated during remote control
OFF: Display shows static image during remote control
*RST: OFF
Example:
SYSTem:DISPlay:UPDate ON
Switch on the display update.
Firmware/Software: V1.0.5.3
7.3.8.3
LAN Services
The following commands define the parameters for LAN connection of the R&S CMW500.
SYSTem:COMMunicate:NET:ADAPter.............................................................................244
SYSTem:COMMunicate:NET:HOSTname........................................................................244
SYSTem:COMMunicate:NET:DHCP................................................................................245
SYSTem:COMMunicate:NET:IPADdress..........................................................................245
SYSTem:COMMunicate:NET:SUBNet:MASK....................................................................245
SYSTem:COMMunicate:NET:GATeway...........................................................................246
SYSTem:COMMunicate:NET:DNS:ENABle......................................................................246
SYSTem:COMMunicate:NET:DNS...................................................................................246
SYSTem:COMMunicate:NET:ADAPter '<Adapter>'
Selects the network adapter and thus the connection type to be modified. All
SYSTem:COMMunicate:NET:... commands affect the selected network adapter. This
command does not activate or deactivate a network adapter. At present only LAN con-
nections are supported.
Parameters:
'<Adapter>' String parameter, see example below.
*RST: a *RST does not affect the LAN service settings
Example:
SYSTem:COMMunicate:NET:ADAPter "Local Area
Connection"
Select a local area (LAN) connection.
Firmware/Software: V1.0.0.4
SYSTem:COMMunicate:NET:HOSTname '<Host>'
Selects the host name (computer name) of the R&S CMW500. The host name (without
the domain) is part of the VISA address string for LAN-based connections.
Parameters:
'<Host>' String parameter, see example below.
*RST: a *RST does not affect the LAN service settings
Instrument-Control Commands