Command Reference
R&S
®
CMW500
264User Manual 1173.9463.02 ─ 02
Example:
TRACe:REMote:MODE:DISPlay:ENABle LIVE
Activate the live mode.
Firmware/Software: V2.1.10
7.3.10 TRIGger Commands
The following commands control the external trigger settings, see External Trigger.
Contents of this chapter
The commands in this section belong to the R&S CMW500 base system; they are not
related to specific firmware applications.
Most of the R&S CMW500 measurement firmware applications provide their own, specific
trigger settings. For details refer to the documentation of the TRIGger... subsystems
in the different firmware application chapters.
TRIGger:BASE:EXTA:CATalog:SOURce..........................................................................264
TRIGger:BASE:EXTB:CATalog:SOURce..........................................................................264
TRIGger:BASE:EXTA:DIRection......................................................................................264
TRIGger:BASE:EXTB:DIRection......................................................................................264
TRIGger:BASE:EXTA:SOURce.......................................................................................265
TRIGger:BASE:EXTB:SOURce.......................................................................................265
TRIGger:BASE:EXTA:CATalog:SOURce?
TRIGger:BASE:EXTB:CATalog:SOURce?
Lists all trigger source values that can be set using
TRIGger:BASE:EXTA|EXTB:SOURce. The returned values depend on the intalled
hardware options and firmware applications.
Return values:
'<Source_1>' ...
'<Source_n>'
Comma separated list of all supported values. Each value is rep-
resented as a string.
Example:
TRIGger:BASE:EXTB:CATalog:SOURce?
Query the available output trigger signals for connector TRIG B.
A possible response is
"No Connection","Base1:
External TRIG A","Base1: External TRIG B".
Usage: Query only
Firmware/Software: V1.0.4.11
TRIGger:BASE:EXTA:DIRection <Direction>
TRIGger:BASE:EXTB:DIRection <Direction>
Selects the TRIG A and TRIG B connectors as either input or output connectors.
Instrument-Control Commands
To Next Page
Loading...
