Command Reference
R&S
®
CMW500
243User Manual 1173.9463.02 ─ 02
Example:
SYSTem:BASE:DEVice:SUBinst?
Returns 0,1 or 0,2 or 1,2.
Usage: Query only
Firmware/Software: V2.0.10
SYSTem:DEVice:ID?
Queries the device identification (independent of sub-instruments).
Return values:
'<DeviceID>' Device ID string.
Usage: Query only
Firmware/Software: V1.0.10.1
7.3.8.2 Display Settings
The following commands configure the appearance of the Graphical User Interface (GUI).
SYSTem:BASE:DISPlay:FONTset...................................................................................243
SYSTem:DISPlay:UPDate..............................................................................................243
SYSTem:BASE:DISPlay:FONTset <FontSize>
Selects the font size for the GUI labels.
Parameters:
<FontSize> DEF | LRG
DEF: Small fonts
LRG: Large fonts
*RST: DEF
Example:
SYSTem:BASE:DISPlay:FONTset LRG
Select large fonts.
Firmware/Software: V1.0.5.3
SYSTem:DISPlay:UPDate <Enable>
Defines whether the display shall be updated or not while the instrument is in the remote
state. If the display (update) is switched off, the normal GUI is replaced by a static image
while the instrument is in the remote state. Switching off the display can speed up the
measurement. This is the recommended state.
See also: Switchover to Remote Control
Instrument-Control Commands
To Next Page
Loading...
