Rohde & Schwarz CMW500 1201.0002K50 - Generator;Signaling Controller Dialog; Blockview Dialog

Basic Instrument Functions
R&S
®
CMW500
113User Manual 1173.9463.02 ─ 02
5.6 Generator/Signaling Controller Dialog
The "Generator/Signaling Controller" dialog gives an overview of the available generator
and signaling firmware applications. It also loads the selected applications configures the
task bar; see Configuring the Task Bar.
To open the dialog press SIGNAL GEN.
Fig. 5-20: Generator/Signaling Controller dialog
► Use the checkboxes in the dialog to display or hide a taskbar entry for a generator or
signaling application.
Notice that up to 8 firmware applications can be active (displayed in the taskbar) simul-
taneously. Remote control of a firmware application is possible without corresponding
active taskbar entry.
5.7 Blockview Dialog
The "Blockview" dialog provides an overview of the configured signal routing settings.
It allows to:
●
display the current allocation of signal path resources to firmware applications
●
display the signal path configured for a firmware application
●
reconfigure the signal path of a firmware application
To open the dialog press BLOCKVIEW.
Generator/Signaling Controller Dialog