Command Reference
R&S
®
CMW500
241User Manual 1173.9463.02 ─ 02
Suffix:
<n>
.
8 to 12
Number of the bit
Return values:
<BitValue> 0 | 1
Example:
STAT:QUES:BIT9:COND?
Query bit no. 9 of the CONDition part of the STATus:QUEStiona-
ble register.
Usage: Query only
Firmware/Software: V1.0.4.11
STATus:QUEStionable:BIT<n>:ENABle <BitValue>
STATus:QUEStionable:BIT<n>:NTRansition <BitValue>
STATus:QUEStionable:BIT<n>:PTRansition <BitValue>
Sets bit no. <n> of the ENABle, NTRansition or PTRansition part of the STATus:QUES-
tionable register, see also Structure of an SCPI Status Register. To set the entire parts
see STATus:QUEStionable:ENABle, STATus:QUEStionable:NTRansition and
STATus:QUEStionable:PTRansition.
Suffix:
<n>
.
8 to 12
Number of the bit
Parameters:
<BitValue> 0 | 1
Example:
STAT:QUES:OPER:BIT9:ENAB 1
Set bit no. 9 of the ENABle part of the STATus:QUEStionable reg-
ister.
Firmware/Software: V1.0.4.11
7.3.8 SYSTem Commands
The SYSTem subsystem contains functions that are not related to instrument perform-
ance. Most of the commands are SCPI-confirmed.
● Device Settings.....................................................................................................242
● Display Settings....................................................................................................243
● LAN Services........................................................................................................244
● Address Settings...................................................................................................247
● Reference Frequency and System Synchronization Settings...............................250
● High Resolution Timer...........................................................................................252
● Miscellaneous Instrument Settings.......................................................................253
Instrument-Control Commands
To Next Page
Loading...
