Command Reference
R&S
®
CMW500
253User Manual 1173.9463.02 ─ 02
SYSTem:TIME:HRTimer:ABSolute:SET
This command sets a timestamp with the current system time. A timer can be started with
a timeout relative to this timestamp, see SYSTem:TIME:HRTimer:ABSolute
on page 252.
An existing timestamp is overwritten.
Return values:
<Timestamp> Seven values, separated by commas:
year, month, day, hour, minutes, seconds, milliseconds
Example:
SYSTem:TIME:HRTimer:ABSolute:SET
Set a timestamp with the current system time.
SYSTem:TIME:HRTimer:ABSolute:SET?
Query the timestamp. Possible result:
2011,3,20,12,5,30,999
Firmware/Software: V2.1.10
SYSTem:TIME:HRTimer:RELative <Timeout>
This command starts a timer. After the specified timeout, an OPC is generated.
When the timer expires, "Operation Complete" is indicated. This event can be evaluated
by polling, via a *OPC? or via *WAI.
Setting parameters:
<Timeout> Range: 0 ms to 4294967295 ms
Default unit: ms
Example:
SYST:TIME:HRT:REL 1000
*OPC?
The commands have the following effects:
Start the timer with a timeout value of 1 second.
Wait until the timer expires before processing the next command.
Usage: Event
Asynchronous command
Firmware/Software: V2.1.10
7.3.8.7 Miscellaneous Instrument Settings
The SYSTem subsystem contains functions that are not related to instrument perform-
ance. Most of the commands are SCPI-confirmed.
SYSTem:BASE:OPTion:LIST..........................................................................................254
SYSTem:BASE:RELiability..............................................................................................255
SYSTem:CONNector:TRANslation...................................................................................255
SYSTem:DATE..............................................................................................................255
SYSTem:ERRor:ALL......................................................................................................256
SYSTem:ERRor:CODE:ALL............................................................................................256
SYSTem:ERRor:CODE[:NEXT].......................................................................................256
Instrument-Control Commands
To Next Page
Loading...
