Preparing for Use
R&S
®
CMW500
40User Manual 1173.9463.02 ─ 02
2. Start one setup file.
3. In the "R&S Software Distributor" dialog enable "Add other setups from current direc-
tory".
As a result the packages of all setup files in the same directory are offered for instal-
lation when you press "Next".
The installation process itself is self-explanatory. For additional information, especially
concerning the options for remote installation, please refer to the online-help of the soft-
ware distributor.
2.9.5 R&S Version Selector
Several software branches can be installed in parallel, but only one of the installed soft-
ware branches is active at a time. The active software is not only stored on the hard disk,
but also present in the flash memory of relevant hardware, e.g. baseband boards and
signaling units. This software branch is started when the instrument is switched on or via
the "CMW" icon on the desktop.
The "R&S Version Selector" allows to change the active software branch, to uninstall
optional software packages and to repair (reinstall) software packages. It can be opened
via an icon on the desktop.
Fig. 2-3: R&S Version Selector
To perform an uninstall, activate or repair action, follow these steps:
1. Select the relevant software branch or software package to the left.
Software Update
To Next Page
Loading...
