Rohde & Schwarz CMW500 - Page 222

Command Reference - Base Software
R&S
®
CMW500
206User Manual 1173.9463.02 ─ 06
SYSTem:ERRor:CODE:ALL?
Queries and at the same time deletes all entries in the error queue.
The command returns the error numbers without any description of the errors. Positive
error numbers are instrument-dependent. Negative error numbers are reserved by the
SCPI standard.
Example:
SYSTem:ERRor:CODE:ALL?
Query all entries in the error queue. "0" is returned if the error
queue is empty.
Usage: Query only
SCPI confirmed
Firmware/Software: V1.0.0.4
SYSTem:
ERRor:CODE[:NEXT]?
Queries and at the same time deletes the oldest entry in the error queue.
The command returns the error number without any description of the error. Positive error
numbers are instrument-dependent. Negative error numbers are reserved by the SCPI
standard.
Example:
SYSTem:ERRor:CODE?
Query the oldest entry in the error queue. "0" is returned if the error
queue is empty.
Usage: Query only
SCPI confirmed
Firmware/Software: V1.0.0.4
SYSTem:ERRor:COUNt?
Queries the number of entries in the error queue.
Example:
SYSTem:ERRor:COUNt?
If the queue is empty, 0 is returned.
Usage: Query only
SCPI confirmed
Firmware/Software: V1.0.0.4
SYSTem:ERRor[:NEXT]?
Queries and at the same time deletes the oldest entry in the error queue. Operation is
identical to that of STATus:QUEue[:NEXT]?.
The entry consists of an error number and a short description of the error. Positive error
numbers are instrument-dependent. Negative error numbers are reserved by the SCPI
standard.
Instrument-Control Commands