Getting Started
R&S
®
CMW500
32User Manual 1173.9463.02 ─ 06
9. Press the "Connect RMC" hotkey to set up a connection.
Note the connection states displayed in the main view and wait until the connection
(the call) has been established.
10. Use the "Go to..." softkey to switch to the "WCDMA Multi Evaluation" measurement
application.
The measurement application is opened and the combined signal path scenario is
selected automatically, i.e. the measurement application is coupled to the signaling
application.
11. Press the "Trigger" softkey followed by the "Trigger Source" hotkey and select a trig-
ger signal provided by the signaling application, e.g. the frame trigger signal.
12. Press "ON | OFF" to start the measurement.
The main view provides an overview of the measurement results.
13. To enlarge a diagram presented in the main view, double-click it.
The following example shows the enlarged "Emission Mask" view.
Fig. 2-5: Spectrum emission mask results
Trying Out the Instrument
To Next Page
Loading...
