R&S
®
CMW 500 Command Reference
Instrument-Control Commands
Operating Manual 1202.3986.32 – 03 123
STATus:PRESet
Configures the status reporting system such that device-dependent events are
reported at a higher level.
The command affects only the transition filter registers, the ENABle registers, and
queue enabling:
The ENABle parts of the STATus:OPERation and STATus:QUEStionable...
registers are set to all 1's.
The PTRansition parts are set all 1's, the NTRansition parts are set to all 0's, so
that only positive transitions in the CONDition part are recognized.
The status reporting system is also affected by other commands, see Reset Values at
the end of the "Remote Control" chapter.
SCPI Confirmed, no query
Example STAT:PRES
Preset the status registers.
Characteristics Firmware version V1.00
*RST value: –
STATus:QUEStionable:CONDition?
Returns the contents of the CONDition part of the status register. Reading the
CONDition registers is nondestructive.
SCPI Confirmed, query only
Example STAT:QUES:COND?
Query the CONDition part of the QUEStionable register to check
for questionable instrument states.
Characteristics Firmware version V1.00
*RST value: –
STATus:QUEStionable:ENABle <NRf>
Sets the enable mask which allows true conditions in the EVENt part of the status
register to be reported in the summary bit. If a bit is 1 in the enable register and its
associated event bit transitions to true, a positive transition will occur in the summary
bit (bit 3 of the STatus Byte).
SCPI Confirmed, command or query
<NRf> 0 to 65535 (decimal representation)
Def. value: – (See also Reset Values at the end of the "Remote
Control" chapter)
Example STAT:QUES:ENAB 1536
To Next Page
Loading...
