Operating the Instrument
R&S
®
RTP
57Getting Started 1337.9946.02 ─ 05
FFT
Transforms a waveform to the frequency spectrum by fast Fourier trans-
form (FFT). The FFT trace is shown in a new diagram.
Tap the icon and adjust the settings in the sidebar. Tap diagram with the wave-
form to be transformed. The FFT diagram is created from the selected waveform.
To adjust FFT settings, double-tap the FFT diagram.
Delete
Removes zoom and histogram areas and their diagrams; measurement
areas and their associated results; and mask segments. The icon also switches
off a waveform.
Tap the icon and then tap the area or diagram to be deleted, or the waveform to
be switched off.
Save Settings
Saves the current instrument settings in a saveset. The filename is created
according to the autonaming pattern. You can reload the saveset using the "Load
saveset (Graphical recall)" toolbar icon, or using [Save Recall] > "Save/Recall" >
"Settings".
Save Screenshot
Saves a screenshot of the current display using the settings defined in
"File" menu > "Print Setup".
Create Report
Creates a report of the current measurement settings and results using the
settings defined in "File" menu > "Report Setup".
Clear all
Deletes all measurement results including long term measurement and
statistics, all waveforms, and the history.
Autoset and Preset
Performs an autoset, or a preset to a default state. The icons have
the same functionality as the corresponding keys on the front panel. They are
useful when you control the instrument remotely.
Toolbar
To Next Page
Loading...
