Operating the Instrument
R&S
®
RTP
60Getting Started 1337.9946.02 ─ 05
1 = Floating result box
2 = Table in a tab on the left or right
3 = Table in a tab above or below
4 = New tab
To open the corresponding setup dialog box
1. In the result box, tap the icon. Alternatively, double-tap the results.
2. If the sidebar opens, tap "Advanced Settings" in the sidebar.
The dialog box with corresponding settings opens.
To define the default position of results
1. Press the [Display] key on the front panel.
2. In the "Display" dialog box, select the "Diagram Layout" tab.
3. Under "Result box", select the "Default position":
● "Preview": result icon on the sidebar
● "Floating": floating result box in front of the diagrams
4. For result boxes of automatic measurements, the docked position is the
default. In docked position, the result table is placed below the diagram. To
change the default position of measurement results, select "Meas" menu >
"Gate/Display" > "Default" position.
Displaying Results
To Next Page
Loading...
