EasyManua.ls Logo

Rohde & Schwarz ZVH4 - 4.1 Volatile Memory

Rohde & Schwarz ZVH4
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Types of Memory and Information Storage in the R&S ZVH
R&S
®
ZVH
4Instrument Security Procedures 1178.4324.02 ─ 02
Memory type Size Content Volatility User
data
Sanitization proce-
dure
Video - SRAM
(main board)
512 kbyte
Display memory (video
memory)
Screen images
Volatile Yes Turn off instrument
power and remove
the separate power
supply unit
Measurement -
SRAM (main
board)
2 Mbyte Intermediate measurement
data
Volatile Yes Turn off instrument
power and remove
the separate power
supply unit
256 kbyte Measurement control data
EEPROM
(front-end
board)
32 kbyte
Hardware information:
Serial number
Product options
Calibration correction
data
Non-volatile No None required (no
user data)
SRAM (main
board)
1 Mbyte or
8 Mbyte
Active instrument and
measurement setup
Active measurement
data
Non-volatile
(battery
backup)
Yes "Sanitize internal
memory" procedure
(see Chapter 5,
"Instrument Declas-
sification",
on page 6)
Flash (main
board)
4 Mbyte or
8 Mbyte
Instrument firmware
Factory default settings
User general settings
User data
User calibration data
Saved user data sets
Non-volatile Yes "Sanitize internal
memory" procedure
(see Chapter 5,
"Instrument Declas-
sification",
on page 6)
4.1 Volatile Memory
The volatile memory in the instrument loses its contents as soon as power is removed
from the instrument. The volatile memory is not a security concern.
Removing power from this memory meets the memory sanitization requirements speci-
fied in the "Clearing and Sanitization Matrix" in section 5.2.5.5.5 of the ISFO Process
Manual for the Certification and Accreditation of Classified Systems under the NIS-
POM.
Video - SRAM
The main board of the R&S ZVH Cable and Antenna Analyzer has one 512 kbyte
SRAM memory device. The SRAM contains the video (display) memory. The
(Video-)SRAM loses its memory as soon as the instrument is switched off and the sep-
arate power supply unit power is removed.
Sanitization procedure: Turn off instrument power and remove the separate power
supply unit
Volatile Memory

Other manuals for Rohde & Schwarz ZVH4

Related product manuals