Rohde & Schwarz ZVH4 - Page 17

R&S ZVH Table of Contents
Operating Manual 1309.6946.12 - 09 2
2.1.2 Distance to Fault Measurements .................................................................................40
2.1.3 1-Port Cable Loss Measurements ...............................................................................41
2.1.4 Transmission Measurements (R&S ZVH-K39) ............................................................42
2.1.5 Selecting the Measurement Format.............................................................................43
2.1.6 Calibrating Measurements ...........................................................................................44
2.2 Configuring Cable and Antenna Tests ....................................................................48
2.2.1 Selecting the Cable Model ...........................................................................................48
2.2.2 Configuring the Horizontal Axis ...................................................................................51
2.2.3 Configuring the Amplitude Characteristics ..................................................................54
2.2.4 Configuring the Tracking Generator ............................................................................56
2.2.5 Setting and Triggering the Sweep ...............................................................................57
2.3 Analyzing Measurement Results ..............................................................................60
2.3.1 Working with Traces ....................................................................................................60
2.3.2 Using Markers ..............................................................................................................62
2.3.3 Using Display and Limit Lines ......................................................................................67
3 Working with the Measurement Wizard .......................................... 68
3.1 Preparing the Measurement .....................................................................................69
3.1.1 Creating a Measurement Set .......................................................................................69
3.1.2 Uploading Measurement Sets .....................................................................................71
3.2 Using the Measurement Wizard ...............................................................................72
3.2.1 Starting the Measurement Wizard ...............................................................................72
3.2.2 Performing a Sequence of Measurements ..................................................................74
3.3 Evaluating Results .....................................................................................................77
4 Spectrum Analyzer Mode (R&S ZVH-K1) ........................................ 78
4.1 Performing Spectrum Measurements ......................................................................78
4.1.1 Measuring Basic Signal Characteristics ......................................................................78
4.1.2 Measuring the Channel Power of Continuously Modulated Signals ............................79
4.1.3 Measuring the Occupied Bandwidth ............................................................................83
4.1.4 Power Measurements on TDMA Signals .....................................................................87
4.1.5 Measuring the Adjacent Channel Leakage Ratio (ACLR) ...........................................90
4.1.6 Measuring the Spectrum Emission Mask ....................................................................99
4.1.7 Measuring the Harmonic Distortion ...........................................................................102
4.1.8 Measuring the AM Modulation Depth ........................................................................104