In the initial state after delivery, PIN protection is turned off. So if you want to protect
the R&S ZVH, you have to turn it on manually.
► Press the SETUP key.
► Press the "Instrument Settings" softkey.
The R&S ZVH shows the "Instrument Settings" dialog box.
► Select the "PIN Code Protection" menu item.
► Press ENTER
The R&S ZVH opens an input field to define a new PIN.
► Enter a 4-digit PIN.
The R&S ZVH opens an input field to confirm the PIN.
► Enter the 4-digit PIN again.
If the PIN confirmation was successful, the R&S ZVH shows a corresponding
message and activates PIN protection. In that case, you have to enter the PIN
every time the R&S ZVH boots.
If the PIN confirmation was not successful, the R&S ZVH shows a corresponding
message and does not activate PIN protection. In that case repeat the last steps.
You can change the PIN any time you want.
► Select the "New PIN Code" menu item.
The R&S ZVH opens an input field to define a new PIN.
► Enter the new PIN.
► Confirm the new PIN.
The R&S ZVH changes the PIN accordingly.
You can define a User Master PIN the same way. By default, the User Master PIN is
the OEM Master PIN as shown in the "Instrument Settings" dialog box.
► Select the "Master PIN Code" menu item.
The R&S ZVH opens an input field to define a User Master PIN.
To Next Page
Loading...
