R&S ZVH Cable and Antenna Test Mode
Analyzing Measurement Results
Operating Manual 1309.6946.12 - 09 63
2.3.2.1 Positioning Markers
► Press the MARKER key.
The marker menu opens.
If, as yet, no marker has been activated, the R&S ZVH automatically activates the
main marker and positions it on the maximum level that has been measured. In
addition, the marker frequency input field opens.
You can perform the following actions:
● Position the marker with the cursor keys.
When positioning the marker with the cursor keys, the step size is 10% of the
span.
● Position the marker with the rotary knob
When positioning the marker with the rotary knob, the step size is one pixel.
● Enter a marker position with the number keys and confirm the entry with one of the
unit keys.
► Confirm the marker position with the ENTER key.
The marker input field closes.
By default, the marker list above the diagram area is active. The marker list shows
the horizontal position of all markers and the corresponding vertical value. If
inactive, the list shows only the coordinates of markers 1 and 2.
You can turn it off and on again whenever you like.
► Press the "View List" softkey.
The marker list turns off or on, depending on its original state.
To Next Page
Loading...
