6
National Rejectors, Inc. GmbH, Buxtehude
START-UP
To avoid damage of any kind during the start-up process,
please carefully check all points specified below:
– suitable connection cable for the respective
interface
– mains voltage in conformity with the specification
on the label
Proceed as follows to install the coin changer in the vending machine:
1 Pull the mains plug of the vending machine.
2 Hang up the coin changer in the vending machine using the three
fastening holes in the rear wall (two at the top and one at the
bottom), see figure below.
To Next Page
Loading...