10
AIR Control
2.3.2.2. Viewing the programme schedule
Pressing the key corresponding any of the days of the
week (1 to 7), you can view your programme schedule
for that day. To modify the programming for that day,
press and follow the steps starting from the point
“Programming or changing”.
2.3.2.3. Erasing the programming
By pressing for 2 seconds while editing the
programme of one or several days, the current
programming will be erased.
If you hold down for 10 seconds, then you will
erase all programmes stored in the remote and switch
into Manual function.
2.4. Selecting the temperature
Pressing or in the Manual function you
canchange the current temperature.
Pressing or in the Automatic function while
editing a programme, will set the temperature for the
current mode (Eco or Comfort) for that hour and all
the hours set in the same mode.
2.5. Activating the Anti-frost mode
Pressing you activate Anti-frost mode. In this
mode, the fixed and invariable temperature is 8 ºC.
In Manual function , pressing the display will
show 8 ºC and the symbol will appear on the
display.
In Automatic function , pressing we set Anti-
frost mode only for the time intervals with no
programming. You will see the symbol on the
display.
2.6. Sending/receiving data
The transfer of data is bidirectional by means of
infrared. This means you can either send the data
from the remote or receive it from the product.
By pressing at a maximum distance of between 1.5
and 2 metres, and a maximum angle of 30º from the
To Next Page
Loading...