Roland Alfa JUNO-2 - Page 30

9.
Naming
the Tone
Colors
You
can write a
name
(within
10 letters) to
each
tone
color, or rename
it.
<
OPERATION
>
(T) Call the
tone
color which
you
wish to
rename.
(2)
Push the Name
Button
®.
The
Display
®
will respond with:
Example
^-v
Cursor Tone Name
(5)
Keep pressing the Name Button
©
until
the
cursor comes under the
letter to be
changed.
The cursor
moves one letter rightward
each time
the Name
Button is pressed.
When the cursor
reaches the right end, it goes back to the beginning.
®
Change the
name
by
using
the a
Dial
O
.
The
available
letters for naming
are
as
follows.
(Space)
<"yf^""
(5)
Repeat the
steps
(3)
®
as many times as
necessary.
®
If the
tone
color to be
written is
in the
Memory
group, set
the
Memory Protect
Switch to
the OFF
position, and
if it is in
the
Cartridge group, set
the Protect
Switch
on
the
cartridge to the
OFF
position.
@
While
holding the Write
Button
(B
down,
select the
tone color to
be
written by
pushing
the relevant Group
Selector
But-
ton
(D
,
the Bank
Selector
Button
(D
and
the
Number
Selector Button
®
.
The Display
®
will change
to:
Example
Renaming M-1
1
While holding
the
Write
Button
®
down.
Cursor
Tone
Color
to be
renamed
Push the
Group
Selector
Button
'
'
"MEMORY".
M-ii
Cursor
Push
the
Bank Selector
f
Button [T].
/ I Push the
Cursor
I
Number
Selector
Button
Q].
-!
i p
f.
New Name
(8)
Return the Memory Protect
Switch
©
or
the
Protect Switch on the
cartridge to the
ON position.
*
Taking the
operation
@
will
automatically
write
the
tone color
selected in the step (T). So
If you
do not
change the
tone color but only
the tone
name,
assign the same tone color
you called in
the step
®.
*
When renaming
the tone
color in the Cartridge,
the
position of
the Memory
Protect Switch
®
has no effect.
30